Only the LS-S5324TP-SI-AC and LS-S5328C-EI-24S support the enhanced load balancing mod

Run:
system-view
The system view is displayed.
Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Run:
load-balance { dst-ip | dst-mac | src-ip | src-mac | src-dst-ip | src-dst-mac }
The load balancing mode of the Eth-Trunk is set.
NOTE:
The S5300SI and S5300LI use the parameter src-dst-ip in the HASH algorithm for load balance regardless of whether you configure this parameter.
Run:
system-view
The system view is displayed.
Run:
load-balance-profile profile-name
A load balancing profile is created and its view is displayed.
Run:
l2 field [ dmac | dport | l2-protocol | smac | sport | vlan ] *
The load balancing mode of Layer 2 packets is set.
Run:
ipv4 field [ dip | dport | l4-dport | l4-sport | protocol | sip | sport | vlan ] *
The load balancing mode of IPv4 packets is set.
Run:
ipv6 field [ dip | dport | l4-dport | l4-sport | protocol | sip | sport | vlan ] *
The load balancing mode of IPv6 packets is set.
Run:
ipv6 field [ dip | dport | l4-dport | l4-sport | protocol | sip | sport | vlan ] *
The load balancing mode of IPv6 packets is set.
Run:
quit
Return to the system view.
Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Run:
load-balance enhanced profile profile-name
The load balancing profile is applied.
NOTE:
The preceding load balancing modes apply only to known unicast traffic. To configure the load balancing mode for unknown unicast traffic, run the unknown-unicast load-balance { dmac | smac | smacxordmac | enhanced }command in the system view. Only the S5300EI, S5310EI, and S5300HI support load balancing configuration for unknown unicast traffic.

More related:
Huawei Low-end Switches Boot Upgrade For BOOTROM
Huawei Low-end Switches Upgrade The APP System
Cisco-Router-IOS Configuration Backup And Recovery
How To Reset Huawei OLT MA5600T Series Equipment Password

Of what use is this post to the general public and the economy.

Pls elucidate

does it have capability for multicast? post the bootstrap if it does. If it does not its a waste of investment as all sip devices nowadays are expected to have dual mode, particularly with vlan option.