Hi guys, Today I’m gonna teach you how to fix satellite dish signal when it says no signal, Some time you may be experience little freezing in pictures or no or bad signal. You can also do it by yourself which can save you some money to pay for satellite tv installer or technician. Believe me, irrespective satellite tv package you are using whether it is DirecTV Or Dish Network Or DStv. The following guidelines needs to be adopted on how to fix satellite dish signal when it lost signal.

Troubleshooting of Satellite Receiver & Cable

Whenever you lost signal on your satellite dish, The first that come to your mind is to verify from your neighbor if that particular channels doesn’t OFF temporarily as a result of technical maintenance upgrade. As usually happened to TStv.

Secondly, You can also check coaxial cable if it still intact. You have to trace the cable from dish to the receiver ensures that there’s no breakage. Also check the F-connector hold the coaxial cable together at both end.

In rare cases, Lightening and thunder can also cause lost of signal or weak signal. After the lightening, thunder always accompany it, So if you experiencing lost of signal or lost of signal on some channels while others are sill working then the decoder or receiver might develop tuner fault or LNB itself. To fix satellite dish signal you have ensure that the coaxial and F-connector were tightly connected. Always Power Off when there’s raining and it may also needs to reboot or do factory reset to work properly. some rules are available for american for installing Consumer-owned antennas and satellites dishes.

How To Fix Satellite Dish Signal: Adjust Or Re-align Satellite Dish

After you have troubleshoot your receiver, Then your satellite dish may need to adjust or re-align, simply because the base and elevation might be shift. To fix satellite dish signal in this situation, You have to get some equipment or tools ready before climb the ladder.

Requirement Tools or Equipment

`A ladder with adequate height to reach satellite dish
Crescent wrench of different size depending on the size of the satellite dish
A compass
A digital receiver or decoder
Television
Signal meter or signal finder
If you experiencing No or bad signal, Weak signal or searching for signal message appeared on your TV Screen. I would suggest you to remove the power cord from either Dish Network or DirecTV Network or DStv receiver for few seconds. If the message still appear on your TV Screen or signal problem still persists. Then you needs to re-align or adjust your satellite dish by adjusting the elevation and azimuth settings.


To read in Full visit the source: https://satgist.com/how-to-fix-satellite-dish-signal-when-it-says-no-signal/