kobams:
Good day Gazzuzz and bosses in the house, I wanna get a naija used Lexus ES350 2008-2011 or a naija used Hyundai Sonata 2012/2013 please which is a better buy?

Es350.

frebor:


Check your dipstick, the correct oil is written on it. Same with the power steering too, check the reservoir cap

Wow. I only just got to know this! Let me check mine and confirm.

Hello GAZZUZZ,
I scanned my car (Toyota Camry 2007 V6) and got code P0420, P0430, P0328 and C1201.

While accelerating, the rpm shoots up and comes down then before the car starts accelerating freely. I guess it happens between gear 1 and 2

GAZZUZZ:



change the faulty knock sensor and the abs wheel speed sensor and try again. Personally looks lts trans related

Thank you. I will surely do that and come back. 🙏
The last time I had that error, my mechanic cleared them and the issues stopped, so he and asked me to drive it and come back for replacement if the issue comes back again.

Fast forward after 2 weeks or so, I started experiencing the issue again while accelerating , and he scanned it and saw that the error codes are back.

Hi Guys 👋 Please help

Recently, I encountered a troubling issue with my 2010 Mercedes-Benz C300. Approximately five days ago, I noticed a significant reduction in acceleration while driving; despite pressing the pedal, the engine would rev without corresponding acceleration. Initially suspecting a faulty fuel pump, I replaced it, but the problem persisted.

Two days ago, while driving, my vehicle gradually lost power until I had to park it. After a short wait, I restarted the engine, and although it moved, the power continued to diminish slowly, allowing me just enough to get home. Seeking a resolution, I took the car for a diagnostic scan, which revealed error codes P0894, P0732, P0735, and P0606, all indicating transmission slipping and gear issues.

Upon checking the transmission fluid, I found it low and refilled it to the appropriate level, yet the issue remained. My technician, unsure of the exact problem, suggested various potential fixes, but I am keen to avoid a trial-and-error approach. Has anyone experienced a similar issue and found a definitive solution? Kindly share